HS-755HB Servo Motor

HS-755HB ¼ Scale Servo

Hitec is pleased to introduce the new HS-755BB featuring the revolutionary Karbonite Gears. The 755 replaced the popular 700BB and offers stronger torque for improved performance. The Karbonite gears are four times stronger than the standard nylon and even after hundreds of thousands of cycles it will not show any signs of wear.

DETAILED SPECIFICATIONS

 Control System: +Pulse Width Control 1500usec Neutral
 Required Pulse: 3-5 Volt Peak to Peak Square Wave
 Operating Voltage: 4.8-6.0 Volts
 Operating Temperature Range: -20 to +60 Degree C
 Operating Speed (4.8V): 0.28sec/60 degrees at no load
 Operating Speed (6.0V): 0.23sec/60 degrees at no load
 Stall Torque (4.8V): 153 oz/in. (11kg.cm)
 Stall Torque (6.0V): 183 oz/in. (13.2kg.cm)
 Operating Angle: 45 Deg. one side pulse traveling 400usec
 360 Modifiable: Yes
 Direction: Clockwise/Pulse Traveling 1500 to 1900usec
 Current Drain (4.8V): 8mA/idle and 230mA no load operating
 Current Drain (6.0V): 8.7mA/idle and 285mA no load operating
 Dead Band Width: 8usec
 Motor Type: 3 Pole Ferrite
 Potentiometer Drive: Indirect Drive
 Bearing Type: 1 Bearing and 1 Oilite Bushing
 Gear Type: Karbonite Gears
 Connector Wire Length: 11.81" (300mm)
 Dimensions: 2.3" x 1.1"x 2.0" (59 x 29 x 50mm)
 Weight: 3.88 oz.. (110g)
 

Operating Speed: .28/.23 sec. at 60^o
Output Torque: 153/183 oz. / 13.2 g.
Size: 2.3"x1.1"x 2.0" 59 x 29 x 50 mm
Weight:  3.88 oz./110 g