HS-325HB Servo Motor

HS-325HB Heavy Duty Ball Bearing Servo

The HS-325HB is the new standard in Ball Bearing Sport servos incorporating the new revolutionary "Karbonite" gear train. Karbonite is four times stronger than our standard white nylon gears and even after hundreds of thousands of cycles it will not show any signs of wear. Add a long life potentiometer for precise centering and an all new custom IC to make the HS-325HB the toughest standard ball bearing servo money can buy.

DETAILED SPECIFICATIONS

 Control System: +Pulse Width Control 1500usec Neutral
 Required Pulse: 3-5 Volt Peak to Peak Square Wave
 Operating Voltage: 4.8-6.0 Volts
 Operating Temperature Range: -20 to +60 Degree C
 Operating Speed (4.8V): 0.19sec/60 degrees at no load
 Operating Speed (6.0V): 0.15sec/60 degrees at no load
 Stall Torque (4.8V): 42 oz/in (3.0 kg/cm)
 Stall Torque (6.0V): 51 oz/in (3.7 kg/cm)
 Current Drain (4.8V): 7.4mA/idle and 160mA no load operating
 Current Drain (6.0V): 7.7mA/idle and 180mA no load operating
 Dead Band Width: 5usec
 Operating Angle: 40 Deg. one side pulse traveling 400usec
 Direction: Clockwise/Pulse Traveling 1500 to 1900usec
 Motor Type: Cored Metal Brush
 Potentiometer Drive: 4 Slider/Direct Drive
 Bearing Type: Top Ball Bearing
 Gear Type: Heavy Duty Karbonite
 360 Modifiable: Yes
 Connector Wire Length: 11.81" (300mm)
 Dimensions: 1.57" x 0.79"x 1.44" (40 x 20 x 36.5mm)
 Weight: 1.52oz (43g)
 

Operating Speed: 0.15 sec/60^o at 6.0V
Output Torque: 3.7 kg/cm (51 oz/in) at 6.0V
Size: 41 x 20 x 37 mm (1.6 x 0.8 x 1.4 in)
Weight:  48g (1.7 oz)