Home > Main Catalog > Servomotors > Servomotors Modified for Continuous Rotation

Continuous Rotation Servo Motors

HSR-1425CR Continuous Rotation Servo

  

Introducing the all new HSR-1425CR Continuous Rotation servo. If you are looking for a servo to pan or tilt your small camera or sensor multiple turns, this is the servo you need. If you are looking for a servo to power the wheels on your small robot, this is the servo you need. Fully proportional speed forward and reverse for precise movements. The potentiometer has been taken out and the dead-band increased to eliminate "creep" that occurs in many other servos that are modified for continuous rotation. Dual ball bearings on the output shaft ensure long lasting performance. Note: This servo does not have position feedback.

DETAILED SPECIFICATIONS

 Control System: +Pulse Width Control 1500usec Neutral
 Required Pulse: 4.8-6.0 Volt Peak to Peak Square Wave
 Operating Voltage Range: 4.8-6.0 Volts
 Operating Temperature Range: -20 to +60 Degree C (-68F to +140F)
 Operating Speed (4.8V): 44 RPM at no load
 Operating Speed (6.0V): 52 RPM at no load
 Operating Torque (4.8V): 38.8 oz-in (2.8 kg-cm)
 Operating Torque (6.0V): 42 oz-in (3.1 kg-cm)
 360 Modifiable: Completed
 Direction: Clockwise/Pulse Traveling 1500 to 1900usec
 Idle Current Drain (4.8V): 3mA at stop
 Idle Current Drain (6.0V): 3mA at stop
 Motor Type: Brushed
 Potentiometer Drive: No Potentiometer
 Bearing Type: Dual Ball Bearing MR106
 Gear Type: Nylon Gears
 Connector Wire Length: 7" (178mm)
 Dimensions: 1.59" x 0.77"x 1.44" (40.6 x 19.8 x 36.6mm)
 Weight: .33oz (41.7g)
 

Operating Speed: 44 RPM/ 52RPM.
Output Torque: 38.8 / 42 oz. 2.8 / 3.1 kg.
Size: 1.59" x 0.77"x 1.44" 40.6 x 19.8 x 36.6mm
Weight:  .33oz 41.7g.

HSR-1425CR - $16.95
Continuous Rotation Servo

Back to Top