|
Home >
Main
Catalog > Servo Motors
> HS-85MG Ball Bearing Micro Servo
Servo Motor Accessories
Servo Motor Controllers (Manual/PC)
|
HS-85MG Ball Bearing Micro Servo |
 |
 |
The HS-85BB features a high power motor for greater speed and torque. Available in both resin and metal gear versions, the HS-85BB is the choice of modelers looking for a high performance servo without breaking the bank. The ball bearing supported output shaft and sturdy gear trains are great for unlimited sailplane flaps and ailerons.
|
Operating Speed: 0.14sec/60° at 6.0V
Output Torque: 3.5kg/cm (48.60 oz/in) at 6.0V
Size: 22 g (0.77 oz)
Weight: 29 x 13 x 30 mm (1.14 x 0.51 x 1.18 in)
|
| DETAILED SPECIFICATIONS |
Control System: +Pulse Width Control 1500usec Neutral
Required Pulse: 3-5 Volt Peak to Peak Square Wave
Operating Voltage: 4.8-6.0 Volts
Operating Temperature Range: -20 to +60 Degree C
Operating Speed (4.8V): 0.16sec/60 degrees at no load
Operating Speed (6.0V): 0.14sec/60 degrees at no load
Stall Torque (4.8V): 41.66 oz/in. (3kg.cm)
Stall Torque (6.0V): 48.6 oz/in. (3.5kg.cm)
Operating Angle: 40 Deg. one side pulse traveling 400usec
360 Modifiable: Yes
Direction: Clockwise/Pulse Traveling 1500 to 1900usec
Current Drain (4.8V): 8mA/idle and 240mA no load operating
Current Drain (6.0V): 8.6mA/idle and 260mA no load operating
Dead Band Width: 8usec
Motor Type: 3 Pole Ferrite
Potentiometer Drive: Direct Drive
Bearing Type: Single Ball Bearing
Gear Type: 4 Metal and 1 Nylon
Connector Wire Length: 6.29" (160mm)
Dimensions: 1.14" x 0.51"x 1.18" (29 x 13 x 30mm)
Weight: 0.80oz (22.1g)
|
Item #HS-85MG $30.95 | |
|
|
